S15/T15 2WD Jimmy L4-151 2.5L (1985)
Figure 2 - Removing the Offset Lever Pin
Remove (Figure 1)
1.
Transmission from vehicle.
-
Refer to Section 7B of the appropriate S/T Service Manual for complete transmission removal procedure.
-
Drain transmission before removal.
Important
Do not let the transmission hang from the clutch.
2.
Speed sensor from extension housing.
3.
Roll pin (663) from offset lever.
-
Place offset lever (659) in 3-4 position of neutral.
-
Use a pin punch and hammer to drive the roll pin (663) through the shift shaft (Figure 2).
Important
Removal of the shift roll pin from the offset lever must be done with the offset lever in the 3-4 position of neutral or the pin may be driven into the
detent/guide plate, damaging the plate and preventing further disassembly of the transmission.
4.
Extension housing (610) from transmission.
-
Remove the eight bolts holding the extension housing to the case.
-
Separate the extension housing from the transmission case and slide rearward. The offset lever (659) will also separate from the shift shaft.
Important
The offset lever is engaged into the extension housing and cannot be removed when the extension housing is mounted to the transmission.
-
Detent ball (662) and detent spring (660) from the detent/guide plate.
-
Clean old sealer from extension housing mating surface.
5.
Roll pin (663) from the offset lever (659).
Important
Failure to remove the roll pin from the offset lever may result in driving the pin into the detent/guide plate during assembly making future
disassembly difficult.
Install (Figure 1)
