S15/T15 2WD Jimmy V6-262 4.3L (1991)
4. Bearing (6) from the clutch rotor hub (5) with J 9398-A.
Important
-
It is not necessary to remove the staking at the rear of the rotor hub to remove the bearing. However, file away the old staked metal to provide
the proper clearance for the new bearing being installed into the rotor bore.
Install or Connect
Tools Required:
J 6083 External Snap Ring Pliers
J 29886 Universal Drive Handle
J 9481-A Pulley and Bearing Installer
J 26271-A Rotor and Bearing Installer
-
Place the rotor and hub assembly face down on a clean, flat surface.
-
Align the bearing with the hub bore.
Installing The Clutch Rotor Bearing
1. Bearing (6) to the rotor hub with J 29886 and J 9481-A.
Staking The Bearing
-
Using a center punch with a 45° angle point, stake 1.1-1.4 mm (0.045-0.055-inch) deep the bearing in three places 120° apart.
