S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
1. Remove 2/3 of the brake fluid from the master cylinder.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Remove the tire and wheel assembly.
4. Inspect the caliper operation.
5. Remove the caliper.
6. Remove the caliper bracket bolts.
7. Remove the caliper bracket from the mounting plate.
8. Inspect the caliper and the caliper bracket.
Installation Procedure
1. Install the caliper bracket to the mounting plate.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the caliper bracket bolts.
-
Tighten the caliper bracket bolts to 70 Nm (52 ft. lbs.).
3. Install the caliper.
4. Install the tire and wheel assembly.
5. Remove the safety stands.
6. Lower the vehicle.
7. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
8. Slowly release the brake pedal.
9. Wait 15 seconds, then repeat steps 6-7 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
10. Fill the brake master cylinder to the proper level.
