S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
5. Install the brake hose fitting, two new gaskets, and the brake hose fitting bolt.
-
Tighten the brake hose bolt to 54 Nm (40 ft. lbs.).
6. Bleed the caliper.
7. Install the tire and wheel assembly.
8. Lower the vehicle.
9. Check the brake system for leaks.
Front (Single Piston)
Brake Caliper Replacement - Front (Single Piston)
Removal Procedure
1. Remove two-thirds of the brake fluid from the master cylinder reservoir.
2. Raise the vehicle and support the vehicle with proper safety stands. Refer to Vehicle Lifting.
3. Remove the tire and wheel assembly.
4. Position a C-clamp over the outer brake pad and the caliper.
4.1.
Tighten the C-clamp until the piston bottoms in the caliper bore.
4.2.
Remove the C-clamp.
