S15/T15 Sonoma P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
Removal Procedure
1. Release the park brake.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Remove the tire and wheel assembly.
Notice: Support the brake caliper with heavy mechanic's wire, or equivalent, whenever it is separated from it's mount and the hydraulic flexible brake
hose is still connected. Failure to support the caliper in this rotor will cause the flexible brake hose to bear the weight of the caliper, which may cause
damage to the brake hose and in turn may cause a brake fluid leak.
4. Remove the rotor.
5. Remove the axle shaft.
6. Remove the park brake shoe.
7. Remove the backing plate nuts.
8. Remove the backing plate from axle housing flange.
Installation Procedure
1. Install the backing plate to the axle housing flange.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the backing plate nuts.
-
Tighten the backing plate bolts to 135 Nm (100 ft. lbs.).
3. Install the park brake shoe.
4. Install the axle shaft.
5. Adjust the park brake shoe.
6. Install the rotor.
7. Install the tire and wheel assembly.
8. Remove the safety stands.
9. Lower vehicle.