Savana 2500 V8-6.6L DSL Turbo (2008)
5. Remove the mounting screws that fasten the EBCM (2) to the brake pressure modulator valve (BPMV) (1).
6. Remove the EBCM (2) from the BPMV (1). Removal may require a light amount of force.
7. Clean the BPMV to EBCM mounting surfaces with a clean cloth.
Installation Procedure
Important: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
1. Install the EBCM (2) on to the BPMV (1).
Notice: Refer to Fastener Notice .
2. Install the screws to the EBCM (2).
Tighten the screws to 5 N.m (44 lb in) in an X-pattern.
3. Connect the electrical connectors to the EBCM.