Savana 2500 V8-6.6L DSL Turbo (2008)
3. Install the hub and rotor assembly to the vehicle. Refer to Rear Axle Hub, Bearing, Cup, and/or Seal Replacement .
4. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
5. Lower the vehicle.
6. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
7. Slowly release the brake pedal.
8. Wait 15 seconds, then repeat steps 6-7 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
9. Fill the master cylinder reservoir to the proper level with clean brake fluid. Refer to Master Cylinder Reservoir Filling (See: Hydraulic
System/Brake Master Cylinder/Service and Repair/Procedures/Master Cylinder Reservoir Filling) .
