Savana 2500 V8-6.6L DSL Turbo VIN 6 (2007)
8. Install the fuel line bracket to the stud.
9. Install the fuel line bracket nut.
Tighten the nut to 16 N.m (12 lb ft).
10. Connect the fuel feed and return lines.
11. Prime the fuel system. Refer to Fuel System Priming.
12. Start the engine. If the engine stalls, repeat the above step.
13. Once the engine starts, inspect for fuel leaks.
14. Install the engine cover.
Fuel Injection Fuel Feed Pipe Replacement - Left Side
Fuel Injection Fuel Feed Pipe Replacement - Left Side
Removal Procedure
1. Remove the engine cover.
2. Remove the upper fan shroud.
3. If equipped, remove the auxiliary generator. Refer to Auxiliary Generator Replacement .
4. Remove the glow plug module and bracket
5. Remove the positive crankcase ventilation (PCV) hose/pipe.
6. Remove the engine harness bracket bolts at the left front of engine and position out of the way.
7. Prior to removing the fuel injector pipes, use compressed air to blow any debris from between the injector line and fittings. Wipe the fittings clean
of debris.
8. Spray lithium grease, GM P/N 12346293 or equivalent, between the fuel injector line and fittings to assist in containing any debris during removal.
