Savana 2500 V8-6.6L DSL Turbo VIN 6 (2007)
1. Install the left fuel feed pipe.
Notice: Refer to Fastener Notice.
2. Connect the fuel feed pipe fitting to the left fuel rail.
Tighten the fittings to 41 N.m (30 lb ft).
3. Connect the fuel feed pipe fittings to the fuel injector pump.
Tighten the fittings to 41 N.m (30 lb ft).
4. If equipped, install the auxiliary generator. Refer to Auxiliary Generator Replacement .
5. Install the A/C compressor.
6. Prime the fuel system. Refer to Fuel System Priming.
7. Start the engine.
If the engine does not start, repeat the above step.
8. Inspect the fuel system for leaks.
Fuel Rail Fuel Feed Pipe Replacement - Right
Fuel Rail Fuel Feed Pipe Replacement - Right Side
Removal Procedure
1. Remove the engine cover.
2. Remove the charge air cooler inlet pipe.
3. Remove the exhaust gas recirculation (EGR) valve.
4. Remove the EGR bracket at front of engine.
5. Remove the fuel line/wire harness bracket bolts left front side of engine and position out of way.
6. Remove the fuel rail bracket bolt under the air cleaner snorkel.
7. Remove the pipe bracket bolt and bracket at front of the engine.
8. Remove the 2 fuel pipe bracket bolts.
9. Disconnect the fuel feed pipe fittings from the left fuel rail.
10. Disconnect the fuel feed pipe from the right fuel rail.
11. Remove the right fuel rail fuel feed pipe.
Installation Procedure
