Savana 2500 V8-6.6L DSL Turbo VIN 6 (2007)
Tighten the pan head tapping screw to 1 N.m (9 lb in).
3. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).
4. Connect the turn signal and multifunction switch assembly connector to the SIR coil connector.
Important: Tighten the screw to 6 N.m (53 lb in).
Important: The abrasion sleeve must be installed back onto the steering column wire harness assembly. The ignition lock cylinder case
wires and connector must be hanging out of the middle of the abrasion sleeve.
5. Install the wire harness assembly (1) into the wire harness strap (2).
6. Install the upper and lower trim covers.
7. Enable the SIR system. Refer to SIR Disabling and Enabling .
Upper Intermediate Steering Shaft Replacement
Upper Intermediate Steering Shaft Replacement
Tools Required
J 42640 Steering Column Anti-Rotation Pin
Removal Procedure