Savana 3/4 Ton Van V6-4.3L VIN X (2003)
9. Remove the accelerator control cable bracket from the throttle body and the intake manifold.
10. Remove the distributor.
11. Remove the spark plug wire harness retainer from the EGR valve inlet pipe.
12. In order to remove the front intake manifold bolt, perform the following:
12.1.
Remove the A/C compressor discharge hose from the vehicle.
12.2.
Remove the A/C compressor suction hose from the vehicle.
12.3.
Remove the drive belt.
12.4.
Loosen the nut for the power steering pump rear bracket.
12.5.
Remove the bolts and the nut for the power steering pump mounting bracket.
12.6.
Leave the A/C compressor, if equipped, and the power steering pump on the bracket.
12.7.
Slide the power steering pump bracket forward to access the bolt at the front of the intake manifold.
13. Remove the engine coolant temperature (ECT) sensor wire connector, if equipped, from the engine wiring harness bracket.
14. Remove the lower intake manifold bolts.
