Savana 3500 V8-4.8L (2009)
2. If replacing the upper differential carrier assembly bushing, install the bushing by performing the following steps:
1. Install the differential carrier assembly bushing into the differential carrier assembly bushing bore.
2. Install the J 45850-2 (2), the J 45850-3 (3), the forcing screw, the thrust bearing, the washers, and the nuts (1) over the differential carrier
assembly bushing as shown.
3. Install the upper differential carrier assembly bushing by holding the lower nut and tightening the upper nut of the J 45850 .
3. Install the differential carrier assembly. Once the differential carrier assembly is installed, remove the piece of tape in order to connect the vent
hose. Refer to Differential Carrier Assembly Replacement (See: Differential Carrier/Service and Repair).