Savana 3500 V8-4.8L (2009)
Differential Mount: Service and Repair
Differential Carrier Assembly Bushing Replacement (Inner Axle Shaft Housing)
Differential Carrier Assembly Bushing Replacement (Inner Axle Shaft Housing)
Tools Required
J 45850 Front Axle Bushing Remover/Installer
Removal Procedure
1. Remove the inner shaft housing. Refer to Front Drive Axle Inner Shaft and Inner Shaft Housing Replacement (See: Service and Repair/Removal
and Replacement/Front Drive Axle/Front Drive Axle Inner Shaft and Inner Shaft Housing Replacement).
2. If replacing the upper inner shaft housing bushing, install the inner shaft housing into a vise.
3. Install the J 45850-2 (2), the J 45850-3 (3), the forcing screw, the thrust bearing, the washers, and the nuts (1) over the upper inner shaft housing
bushing as shown.
4. Remove the upper inner shaft housing bushing by holding the lower nut and tightening the upper nut of the J 45850 .