Savana 3500 V8-6.6L DSL Turbo VIN 6 (2007)
Installation Procedure
1. Install the turn signal and multifunction switch assembly (2) onto the steering column tilt head assembly.
Notice: Refer to Fastener Notice .
Important: Be sure that the electrical contact of the turn signal and multifunction switch assembly (2) rests on the turn signal cancel cam
assembly.
2. Screw the 2 pan head tapping screws (1) and (3) into the turn signal and multifunction assembly (2).
Tighten the pan head tapping screw to 1 N.m (9 lb in).
3. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).
4. Connect the turn signal and multifunction switch assembly connector to the SIR coil connector.
Important: Tighten the screw to 6 N.m (53 lb in).
Important: The abrasion sleeve must be installed back onto the steering column wire harness assembly. The ignition lock cylinder case
wires and connector must be hanging out of the middle of the abrasion sleeve.
