Sierra 1500 2WD V8-6.0L Hybrid (2010)
1. Install new APM coolant seal (3).
2. Position the APM (2) onto the PIM ensuring the seals remain in place.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the APM mounting fasteners (1). Tighten the mounting fasteners to 10 Nm (89 lb in).
4. Rotate the drive motor generator control module assembly onto the APM.
5. Clamp GE-48494 - adapter kit components (2, 3) to a coolant pipe.
6. Plug the remaining coolant pipe with GE-48494 - adapter kit plug and clamp (1).
7. Apply 20 psi (138 kPa) pressure with J 24460-01 - pressure tester (4).
8. Monitor the pressure tester gauge for 5 minutes and ensure that pressure remains at the specified value.
*
If the specified pressure cannot be maintained, disassemble the drive motor generator control module assembly and replace the coolant seals.
*
If pressure remains at the specified value, proceed to the next step.
