Sierra 3500 Denali 2WD V8-6.0L (2011)
Shift Cable: Service and Repair
4L60-E/4L65-E/4L70-E - Automatic Transmission
Range Selector Lever Cable Replacement
Range Selector Lever Cable Replacement
Removal Procedure
Warning
The automatic transaxle range selector cable is made out of two cable sections. After initial connection never separate the two metal couplings from one
another. Integrity of the connection of the two metal couplings will be lost if separation of the two metal couplings occurs. When servicing the transaxle
remove the cable at the automatic transaxle range selector lever and at the automatic transaxle range selector cable bracket. If either section of the cable
needs to be replaced, replace both of the cable sections. Loss of connection integrity of the two metal couplings can cause loss of transaxle shift control
which could result in personal injury.
1. Position the steering column shift lever to the park position.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
3. Remove the clips on the cable from the floor panel reinforcement.
4. Ensure the transmission manual shaft is positioned in mechanical park.
5. Remove the retainer that secures the cable to the bracket.
6. Remove the cable clip on the transfer case, if equipped.
