Accord L4-1955cc 2.0L SOHC 2-bbl (1986)
4. Remove the stator coil by removing the large circlip.
5. Assemble the clutch in the reverse order of disassembly, noting the following:
-
Install the snap ring with its chamfered side facing out.
-
When installing the snap ring, be careful not to damage the aluminum compressor snout.
-
Clean pressure plate and pulley surfaces with non-petroleum solvent.
-
Tighten the hub nut to specified torque.
Torque: 20 Nm (15 lb ft)
-
Recheck the pulley-to-pressure plate clearance and adjust if necessary.
