Accord L4-2.2L SOHC VTEC (1994)
Spark Plug Wires: Testing and Inspection
CAUTION: Carefully remove the ignition wires by pulling on the rubber boots. Do not bend the wires; you might break them inside.
Ignition Cable Visual Inspection
1. Check the condition of the wire terminals. If any terminal is corroded, clean it, and if it is broken or distorted, replace the wire.
Ignition Cable Resistance Measuring
2. Connect ohmmeter probes and measure resistance.
Ignition Wire Resistance: 25k Ohms max. at 20°C (68°F)
3. If resistance exceeds 25k Ohms, replace the ignition wire.
