Accord L4-2.4L (2005)
Brake Pad: Service and Repair
Rear
Rear Brake Pad Inspection and Replacement
CAUTION: Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health.
^
Avoid breathing dust particles.
^
Never use an air hose or brush to clean brake assemblies. Use an OSHA-approved vacuum cleaner.
Inspection
1. Raise the rear of the vehicle, and support it with safety stands in the proper locations.
2. Remove the rear wheels.
3. Check the thickness of the inner pad (A) and outer pad (B). Do not include the thickness of the backing plate.
4. If the brake pad thickness is less than the service limit, replace all the rear brake pads as a set.
Replacement
1. Raise the rear of the vehicle, and support it with safety stands in the proper locations.
2. Remove the rear wheels.
3. Remove the flange bolts (C) while holding the pin A and pin B with a wrench being careful not to damage the pin boots, and remove the caliper
(D). Check the hose and pin boots for damage and deterioration.
4. Remove the pad shim (A) and brake pads (B).
