Accord V6-3.0L Hybrid (2005)
1.
Apply masking tape to the edges of the headliner and the rear window to avoid getting adhesive on them.
2.
Pull down the headliner near one of the rear clip holders. Pull down the headliner carefully to avoid creasing it. Use coarse-grade sandpaper (about
60 grit) to roughen the headliner area under the clip holder. Sand the area for 15 to 30 seconds. Repeat this step under the other clip holder.
NOTE:
This step ensures that the headliner sticks properly to the clip holders.
*3.
Moisten a clean cloth with water, and wipe off any dust from the sanded areas. Make sure the headliner is dry before applying adhesive.*
4.
Following the manufacturer's instructions, prepare a small amount of adhesive in a container.
