Accord Coupe L4-2.2L SOHC VTEC (1995)
Fuel Gauge: Testing and Inspection
1. Check No. 1 (10A) fuse in under dash fuse/relay box before testing.
Fig. 3 Fuel Gauge Sending Unit
2. Connect voltmeter positive probe to blue/yellow terminal and negative probe to black terminal, then turn ignition switch to On position.
3. Voltage should be between 5-8 volts.
4. If voltage is not as specified, check the following:
a. Check open yellow/blue wire.
b. Check blown fuse or poor ground.
5. Turn ignition switch On, then check as pointer of fuel gauge starts moving toward F mark. Turn ignition switch to Off before pointer reaches F
mark on gauge dial. Failure to do so may damage fuel gauge.
6. If pointer of fuel gauge does not move, replace gauge.
7. If gauge is satisfactory, inspect fuel gauge and sending unit.
