honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 5285 > < Initial Inspection and Diagnostic Overview|Page 5283
Page 5
background image

Is there battery voltage?

YES - Go to step 8.

NO - Repair open in the wire between the No. 36 (10 A) in the under-dash fuse/relay box and the buzzer.

8. Turn the ignition switch to LOCK (0).
9. Disconnect the servo unit 25P connector.

10. Check for continuity between buzzer 2P connector terminal No. 1 and servo unit 25P connector terminal No. 5.

Is there continuity?

YES - Go to step 11.

NO - Repair open in the wire between the buzzer and the servo unit.

11. Reconnect all connectors.
12. Turn the ignition switch to ON (II).
13. Connect buzzer 2P connector terminal No. 1 to body ground with a jumper wire.

Does the buzzer sound?

YES - Replace the servo unit.

NO - Replace the buzzer.

Buzzer Sounds Continually

Initial Inspection and Diagnostic Overview|Page 5285 > < Initial Inspection and Diagnostic Overview|Page 5283