Civic L4-1.3L Hybrid (2008)
Bleeding - Normal Brake (Except Servo Unit and Power Unit)
NOTE:
^
The brake fluid reservoir tank must beat least 1/2full at the start of the bleeding procedure and checked after bleeding each brake caliper or wheel
cylinder. Add fluid as required.
^
Turn the ignition switch to LOCK (0) while doing this procedure.
1. Turn the ignition switch to LOCK (0).
2. Press the brake pedal several times until it becomes a hard brake pedal to release the pressure in the accumulator.
3. Make sure the brake fluid level in the reservoir tank (A) is at the middle of the tank line (B).
4. Have someone slowly pump the brake pedal several times, then apply steady pressure.
5. Start the bleeding at the driver's side of the front brake system.
NOTE: Bleed the calipers or the wheel cylinders in the sequence shown.
6. Attach a length of clear drain tube (A) to the bleed screw (B), then loosen the bleed screw to allow air to escape from the system. Then tighten the
bleed screw securely.
