Civic L4-1.3L Hybrid (2008)
5. Add the brake fluid to the reservoir tank (A) and keep the level at the middle line (B).
6. Attach a length of clear drain tube (A) to the bleed screw (B) under the servo unit (C), and loosen the bleed screw.
NOTE: Turn the bleed screw about 180°.
7. Turn the ignition switch to ON (II), and add the brake fluid to the reservoir tank.
NOTE: Do not operate the pump motor for more than 110 seconds or it may be damaged.
8. Make sure the brake fluid is discharged from the bleed screw to allow air to escape from the system, then tighten the bleed screw securely.
9. Turn the ignition switch to LOCK (0).
10. Add the brake fluid in the reservoir tank, and keep it at the middle of the tank line.
11. Turn the ignition switch to ON (II).
12. Wait several seconds until the AHB indicator and/or brake system indicator goes off.
13. Turn the ignition switch to LOCK (0).
