Civic L4-1668cc 1.7L SOHC MFI (2003)
85. Hold the gearbox housing using a C-clamp, then install the special tool on the lock screw (A). Retighten the lock screw to specified torque values.
86. Remove the special tool. Retighten the 12 mm flange bolts (A) to specified torque values. After tightening the 12 mm flange bolts, install a new
lock washer (B) over one of bolt the heads (C). Be sure the tabs (D) of the lock washer are aligned with the flat surfaces (E) of the bolt head.
87. Clean off any grease or contamination from the boot installation grooves around on the housing.
88. Expand boot (A) by removing the vinyl tape, and fit the boot ends (B) in the installation grooves on the cylinder housing.
89. Close the ear portion (A) of the bands (B) with a commercially available pincers, Oetiker 1098 or equivalent (C).
