CR-V LX 4WD L4-1972cc 2.0L DOHC MFI (2000)
3. Mark each roller and inboard joint to identify the locations of rollers and grooves in the inboard joint. Then remove the inboard joint on the shop
towel. Be careful not to drop the rollers when separating them from the inboard joint.
4. Mark the rollers and spider to identify the locations of rollers on the spider, then remove the rollers.
5. Remove the circlip.
6. Mark the spider and driveshaft to identify the position of the spider on the shah.
7. Remove the spider using a bearing remover.
8. Wrap the splines on the driveshaft with vinyl tape to prevent damage to the boots and dynamic damper.
9. Remove the boot band and inboard boot. Take care not to damage the boot.
10. Remove the dynamic damper band and dynamic damper. Take care not to damage the dynamic damper.
