Del Sol Si VTEC L4-1590cc 1.6L DOHC (VTEC) MFI (1997)
_mfi/Page-1437016.png)
48. Set the selected 32 mm shims on the bearing surface of the gearbox housing.
49. Coat the new O-ring with grease and install it in the groove in the gearbox housing.
50. Apply grease to the needle bearing in the gearbox housing.
51. Install the valve body unit on the gearbox housing by engaging the gears.
NOTE: Note the valve body unit installation position (direction of line connection).
52. Tighten the flange bolts to the specified torque.
53. Install the cylinder lines A and B.
NOTE:
-
Clean the joints of the cylinder line A and B thoroughly. The joints must be free of foreign material.
-
Install the cylinder line A and B by fighting the flare nuts by hand first, then tighten the flare nuts to the specified torque starting with the
cylinder side nuts.
