Fit L4-1.5L (2008)
2. Apply a thin coat of silicone grease to the new O-ring (B), and carefully fit it on the EPS motor.
3. Apply grease (Shell steering gear grease or Honda's equivalent steering gear grease) into the EPS motor shaft (C).
4. Install the EPS motor on the steering gearbox by engaging the EPS motor shaft and the worm shaft (D).
5. Before tightening the bolts, turn the EPS motor two or three times to the right and left about 45 degrees. Make sure the EPS motor is evenly seated
on the steering gearbox, and that the O-ring is not pinched between the mating surfaces.
6. Install the heat shield, and in two or more steps, alternately tighten the three bolts on the steering gearbox to the specified torque.
7. Install the EPS motor angle sensor 6P connector (A), the EPS motor 1P connector (B), the EPS motor 2P connector (C), and the clip (D) to the
connector bracket(E).
8. Install the connector bracket.
9. Finish the installation, make sure the EPS motor and the EPS wires are not caught or pinched by any parts.
10. Install the steering gearbox.
