Passport EX 2WD V6-3.2L DOHC (6VD1) (1998)
/Page-410002.png)
11. Remove the timing belt covers in this order: right, left, then lower.
12. Loosen (don't remove) the tensioner pulley bolt.
13. Remove the idler pulley bolt, and let the idler pulley pivot towards the crankshaft timing pulley.
14. Remove the lower tensioner bolt and the tensioner pusher.
15. Carefully remove the timing belt from the pulleys.
ENGINE TIMING
1. Turn the crankshaft timing pulley until its notch aligns with the mark on the oil pump housing. NOTE: The crankshaft timing pulley may have a
green mark 150 degrees from its keyway. Do not use this mark to set the crankshaft position.
2. Turn the right cylinder bank's camshaft pulley clockwise with a socket and ratchet. (The pulley clicks and stops several times.) Stop the pulley
when its green mark aligns with the valve cover timing mark.
NOTE:
You may need to rotate the camshaft pulley up to four complete turns before its green mark aligns directly with the valve cover timing mark.
3. Turn the left cylinder bank's camshaft pulley clockwise with a socket and ratchet. (The pulley clicks and stops several times.) Stop the pulley when
its green mark aligns with the timing belt cover bolt hole.
