Passport LX 4WD V6-3165cc 3.2L DOHC MFI (2001)
-
Top edge (1) and bottom edge (3) primer coat areas.
3. Stick the fasteners tape to the body in the specified locations.
4. Install the rear quarter glass assembly (1).
-
Apply the primer (4) to the rear quarter glass as shown in the figure.
-
Stick the dam seal (2) in place and then apply adhesive (3), as shown in the figure.
-
Allow a 20 mm (0.79 in) overlap at the ends of the adhesive.
-
Insert the glass clips into the hole in the panel and then push the glass against the panel to affix it in place.
