Pilot V6-3.5L (2004)
15. Install the clips to the body.
16. Set the windshield in the opening, and center it. Make alignment marks (A) across the windshield and body with a grease pencil at the four points
shown. Be careful not to touch the windshield where adhesive will be applied.
17. Remove the windshield.
18. With a sponge, apply a light coat of glass primer around the edge of the windshield (A) between the upper rubber dam (B), side rubber dam (C),
lower rubber dam (D), and molding (E) as shown, then lightly wipe it off with gauze or cheesecloth:
-
Apply glass primer to the molding.
-
Do not apply body primer to the windshield and do not get body and glass primer sponges mixed up.
-
Never touch the primed surfaces with your hands If you do, the adhesive may not bond to the windshield properly, causing a leak after the
windshield is installed.
-
Keep water, dust and abrasive materials away from the primed surfaces.
