Pilot 2WD V6-3.5L (2006)
Power Mirror Motor: Service and Repair
Power Mirror Actuator Replacement
1. Remove the power mirror and mirror holder.
2. Disconnect the 8P connector from the mirror actuator.
3. Record the terminal location and wire colors, then cut the mirror actuator wires with the wire cutter.
4. Remove the two Torx screws from the mirror connector (A), then remove the connector and cover (B).
5. Remove the four Torx screws and separate the actuator (A) from the mirror housing (B).
6. Route the wire harness (A) of the new actuator through the hole in the bracket (B).