Prelude L4-1958cc SOHC (1988)
6.
Remove the air cleaner case.
7.
Disconnect the drain tube from the charcoal canister, then remove the canister from its bracket (the canister slides upward off the bracket.)
8.
Remove the P/S supply hose from its clamps on the rear beam.
9.
Place a clean protective cloth over the alternator, remove the two bolts at the joint of the P/S pump and the P/S supply hose, then separate the
P/S supply hose from the pump.
10.
Remove the P/S supply hose bracket bolts on the cylinder block (8 mm) and the thermostat housing (6 mm).
11.
Disconnect the ground wires from the thermostat housing.
12.
Disconnect the water temperature sender, remove the high tension wire clamp, and the transmission throttle cable from its holder.
13.
Raise the vehicle and remove the valve body splash shield.
