Ridgeline V6-3.5L (2006)
Rear Bumper: Service and Repair
Rear Bumper Step
Rear Bumper Step Replacement
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program
NOTE:
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
-
Take care not to scratch the bumper.
1. Using a trim tool, detach the hooks (A, B), then remove the left rear bumper step (C), center rear bumper step (D), and right rear bumper step (E).
2. Install the bumper step by pushing on the hook portions until the hooks snap into place.
