Ridgeline V6-3.5L (2006)
9. Install the VSA rear wheel sensor (A).
10. Install a new spindle nut (A), then tighten the nut. After tightening, use a drift to stake the spindle nut shoulder (B) against the driveshaft.
11. Clean the mating surfaces of the brake disc and the rear wheel, then install the rear wheel with the wheel nuts.
12. Turn the rear wheel by hand, and make sure there is no interference between the driveshaft and surrounding parts.
13. Refill the differential with recommended fluid.
14. Check the rear wheel alignment, and adjust it if necessary.
