S2000 L4-2.2L (2004)
59. Install the water bypass hose (A), and tighten the three bolts (B) securing the water bypass tube.
60. Install the alternator-compressor belt.
61. Install the vacuum tank.
62. Install the air cleaner housing/intake air duct assembly, then install the vacuum hoses. Connect the air control solenoid valve connector (see step
43).
63. Install the throttle cable, then adjust the cable.
64. After installation, check that all tubes, hoses and connectors are installed correctly.
65. After assembly, wait at least 30 minutes before filling the engine with oil.
66. Refill the radiator with engine coolant, and bleed air from the cooling system with the heater valve open.
67. Inspect for fuel leaks. Turn ON (II) the ignition switch (do not operate the starter) so that the fuel pump runs for about 2 seconds and pressurizes
the fuel line. Repeat this operation two or three times, then check for fuel leakage at any point in the fuel line.
68. Inspect the idle speed.
69. Inspect the ignition timing.
70. Enter the anti-theft code for the radio, then enter the customer's radio station presets.
