H2 V8-6.2L (2008)
1. Open both front and rear side doors.
2. Remove the weatherstrip (2) by pulling the weatherstrip off of the pinch-weld flange (1).
Installation Procedure
1. Starting at the center of the door openings, install the weatherstrip (2) to the pinch-weld flange (1) and work across the right and left sides towards
the ends of the weatherstrip, being careful not to stretch the weatherstrip during installation.
2. Close the door.
Rear Door Opening Weatherstrip Replacement
Rear Door Opening Weatherstrip Replacement
Removal Procedure
1. Open the door.
2. Remove the weatherstrip (2) by pulling the weatherstrip off of the door opening pinch-weld flange (1).
Installation Procedure
