H2 V8-6.2L (2008)
*
Use a backup wrench on the brake hose fitting end (2).
*
Do not bend the mounting bracket or the brake pipe.
Tighten the brake pipe fitting end (1) to 25 N.m (18 lb ft).
9. Bleed the hydraulic brake system. Refer to in Hydraulic Brake System Bleeding (Manual) (See: Brake Bleeding/Service and Repair/Hydraulic
Brake System Bleeding (Manual))Hydraulic Brake System Bleeding (Pressure) (See: Brake Bleeding/Service and Repair/Hydraulic Brake
System Bleeding (Pressure)) .
10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair) .
Important: Ensure that the brake hose does not make contact with any part of the suspension or the tire/wheel assembly. Check the
brake hose in extreme right and left turn conditions. If the brake hose makes contact remove the brake hose and correct the condition.
11. Lower the vehicle.
