H2 V8-6.2L (2008)
Installation Procedure
Important: Install 2 new copper brake hose gaskets.
1. Assemble the 2 new copper brake hose gaskets and the brake hose bolt to the brake hose.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
2. Install the brake hose to caliper bolt and 2 new washers to the brake caliper.
Tighten the bolt to 40 N.m (30 lb ft).
Important: The brake hose must not be twisted. Make sure the brake hose is not in contact with any suspension component.
3. Install the brake hose bracket bolt and the bracket to the steering knuckle.
Tighten the bolt to 14 N.m (124 lb in).
4. Install the brake hose bracket bolt and the bracket to the upper control arm.
Tighten the bolt to 9 N.m (80 lb in).
5. Install the brake hose into the brake hose bracket.
6. Install the brake hose retaining clip (3).
7. Remove the rubber cap or plug from the brake pipe fitting end.
8. Connect the brake pipe fitting end (1) to the brake hose (2):
