H2 V8-6.2L (2008)
8. Install the cable (3) to the lever (2).
9. install the cable (3) to the backing plate (1) by compressing the spring, routing the cable through the slot in the backing plate and pressing the
cable into the backing plate until the locking tabs snap into place.
10. Install the caliper and mounting bracket as an assembly. Refer to Rear Disc Brake Pads Replacement (See: Disc Brake System/Brake Pad/Service
and Repair/Rear Disc Brake Pads Replacement) .
11. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair) .
12. Remove the safety stands.
13. Lower the vehicle.
14. Enable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Enabling (See: Parking Brake Cable/Service and
Repair/Procedures/Parking Brake Cable Adjuster Enabling) .
