H2 V8-6.2L (2008)
Engine Mount: Service and Repair
Engine Mount Replacement - Right
Engine Mount Replacement - Right Side
Removal Procedure
1. Remove the engine mount-to-frame bracket bolts.
2. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance) .
3. Remove the engine shield bolts.
4. Remove the engine shield.
5. Remove the air conditioning (A/C) compressor. Refer to Compressor Replacement (See: Heating and Air Conditioning/Compressor
HVAC/Service and Repair/Removal and Replacement/Compressor Replacement) .
6. Remove the starter motor. Refer to Starter Motor Replacement (See: Starting and Charging/Starting System/Starter Motor/Service and Repair) .
Important: DO NOT raise and/or support the engine by the crankshaft balancer, or oil pan.
7. Raise and suitably support the engine using adjustable (screw type) jack stands.
8. Remove the engine mount bolts (left side shown, right side similar).
9. Remove the right engine mount.
Installation Procedure