H2 V8-6.2L (2008)
1. Position the right engine mount to the engine (left side shown, right side similar).
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
2. Install the engine mount bolts.
Tighten the engine mount bolts to 50 N.m (37 lb ft).
3. Lower the engine.
4. Remove the adjustable jack stands.
5. Install the starter motor. Refer to Starter Motor Replacement (See: Starting and Charging/Starting System/Starter Motor/Service and Repair) .
6. Install the A/C compressor. Refer to Compressor Replacement (See: Heating and Air Conditioning/Compressor HVAC/Service and
Repair/Removal and Replacement/Compressor Replacement) .
7. Position the engine shield to the vehicle.
8. Install the engine shield bolts.
Tighten the engine shield bolts to 30 N.m (22 lb ft).
9. Lower the vehicle.
10. Install the engine mount-to-frame bracket bolts.
Tighten the engine mount-to-frame bracket bolts to 65 N.m (48 lb ft).
