H2 V8-6.2L (2008)
If the torque is outside this range, readjust or repair the steering gear assembly as required.
12. To obtain the correct reload torque, adjust the over center preload by turning the steering gear pitman shaft lash adjuster screw clockwise.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
13. Add increments of 0.7-1.1 N.m (6-10 lb in) torque to the previously measured steering gear worm bearing preload torque.
Tighten the nut to 49 N.m (36 lb ft).
14. Install the steering gear. Refer to Steering Gear Replacement (See: Steering Gear Replacement) .
