H2 V8-6.2L (2008)
Steering Gear: Service and Repair
Steering Gear Pitman Shaft Over-Center Preload Adjustment - Off Vehicle
Steering Gear Pitman Shaft Over-Center Preload Adjustment - Off Vehicle
1. Remove the steering gear. Refer to Steering Gear Replacement (See: Steering Gear Replacement) .
2. Loosen the steering gear pitman shaft lash adjuster nut (4).
3. Turn the steering gear pitman shaft lash adjuster screw (1) counterclockwise until fully extended.
4. Turn the steering gear pitman shaft lash adjuster screw (1) clockwise one full turn.
5. Rotate the steering gear stub shaft (3) from stop to stop, using a 12-point socket while counting the number of turns.
6. Starting at either stop, turn the steering gear stub shaft (3) back half the total number of turns counted previously. This is the centered position.
7. Make sure the steering gear pitman shaft is centered by checking the following items:
*
The flat on the steering gear stub shaft (2) faces upward.
*
The flat on the steering gear stub shaft is parallel with the steering gear side cover.
*
The master spline (3) on the steering gear pitman shaft is in line with the steering gear pitman shaft lash adjuster screw (1).
8. Place a torque wrench on the stub shaft with the handle in the vertical position.
9. Rotate the steering gear stub shaft 45 degrees from each side of the center of the steering gear stub shaft. The steering gear stub shaft must rotate
smoothly and must not stick or bind.
10. Record the steering gear worm bearing preload measured on or near the center.
Important: Prevent the steering gear pitman shaft lash adjuster screw from turning while tightening the steering gear pitman shaft lash
adjuster nut.
11. Recorded steering gear worm bearing preload must be 0.8-1.7 N.m (7.1-15.1 lb in), with the steering gear pitman shaft lash adjuster nut installed.
