H2 V8-6.2L (2008)
3. Install the upper control arm retaining bolt to the frame bracket.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
Important: Do not tighten the nuts unless the suspension is at the curb height position.
4. Install the upper control arm to axle bolt and nut.
Tighten the nut to 150 N.m (111 lb ft).
Important: Do not tighten the bolts unless the suspension is at the curb height position.
5. Install the upper control arm to frame bolt .
Tighten the bolt to 150 N.m (111 lb ft).
6. Connect the air suspension level sensor, if equipped. Refer to Air Spring Leveling Sensor Replacement (See: Suspension Control ( Automatic -
Electronic )/Service and Repair/Removal and Replacement/Air Spring Leveling Sensor Replacement) .
7. Remove rear axle support.
8. Lower the vehicle.
Rear Axle Lower Control Arm Replacement
Rear Axle Lower Control Arm Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance) .
2. Support the rear axle at curb height.
3. Remove the fuel tank shield. Refer to Fuel Tank Shield Replacement (See: Powertrain Management/Fuel Delivery and Air Induction/Fuel
Tank/Fuel Tank Shield/Service and Repair) .
4. Remove the lower control arm retaining nuts.
5. Remove the lower control arm retaining bolt.
6. Remove the lower control arm.
Installation Procedure
