H2 V8-6.2L (2008)
1. Install the lower control arm.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
Important: Do not tighten the bolts unless the suspension is at the curb height position.
2. Install the lower control arm to axle bolt and nut.
Tighten the bolt to 250 N.m (184 lb ft).
Important: Do not tighten the bolts unless the suspension is at the curb height position.
3. Install the lower control arm to frame bolt and nut.
Tighten the bolt to 250 N.m (184 lb ft).
4. Install the fuel tank shield. Refer to Fuel Tank Shield Replacement (See: Powertrain Management/Fuel Delivery and Air Induction/Fuel
Tank/Fuel Tank Shield/Service and Repair) .
5. Remove the rear axle support.
6. Lower the vehicle.
