H2 V8-6.2L (2008)
Fluid - Differential: Removal and Replacement
Front Drive Axle
Front Axle Lubricant Replacement
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance) .
2. Remove the front differential carrier shield, if equipped. Refer to Engine Protection Shield Replacement (See: Body and Frame/Frame/Skid
Plate/Service and Repair) .
3. Clean the area around the front axle fill plug and the drain plug.
4. Remove the fill plug (1).
5. Remove the drain plug (2).
6. Drain the fluid from the front axle differential.
Installation Procedure
Notice: Refer to Fastener Notice .
1. Install the drain plug (2).
Tighten the drain plug to 33 N.m (24 lb ft).
2. Fill the front differential with lubricant. Use the proper fluid. Refer to Approximate Fluid Capacities (See: Maintenance) and Fluid and Lubricant
Recommendations (See: Maintenance) .
3. Install the fill plug (1).
Tighten the fill plug to 33 N.m (24 lb ft).
4. Install the front differential carrier shield, if equipped. Refer to Engine Protection Shield Replacement (See: Body and Frame/Frame/Skid
Plate/Service and Repair) .
5. Lower the vehicle.
Rear Drive Axle
Rear Axle Lubricant Replacement