H2 V8-6.2L (2008)
Fluid - Differential: Procedures
Front Drive Axle
Front Axle Lubricant Level Inspection
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance) .
2. Make sure the vehicle is level.
3. Inspect the front axle for leaks. Repair as necessary.
4. Remove the engine protection shield (if equipped). Refer to Engine Protection Shield Replacement (See: Body and Frame/Frame/Skid
Plate/Service and Repair) .
5. Clean the area around the front axle fill plug (1).
6. Remove the front axle fill plug (1).
7. Inspect the oil level.
The oil level should be between 0-10 mm (0-0.375 in) below the fill plug opening.
8. If the level is low, add oil until the level is even with the bottom edge of the fill plug opening. Use the proper fluid. Refer to Fluid and Lubricant
Recommendations (See: Maintenance) .
Notice: Refer to Fastener Notice .
9. Install the fill plug.
Tighten the plug to 33 N.m (24 lb ft).
10. Install the engine protection shield. Refer to Engine Protection Shield Replacement (See: Body and Frame/Frame/Skid Plate/Service and Repair) .
11. Lower the vehicle.
Rear Drive Axle
Rear Axle Lubricant Level Inspection
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance) .
2. Make sure the vehicle is level.
3. Inspect the rear axle for leaks. Repair as necessary.
4. Clean the area around the rear axle fill plug.
