Accent L Hatch Back L4-1495cc 1.5L SOHC MFI (2000)
11.
Apply a thin bead of Loctite 603 (or Permatex 60940) around the diameter of the new aluminum PCV elbow and spread the Permatex to coat the
outer surface:
KIT # 2, P/N 28312-22700-D 30.25 mm diameter; 1 .5L SOHC
KIT # 3, P/N 28312-26700-D 35.29 mm diameter; 1.6L DOHC.
NOTE:
Use the Loctite sparingly. Applying too much will not allow the product to cure properly.
12.
Insert the PCV elbow into the hole where the expansion plug was removed.
NOTE:
The new PCV elbow is already connected to the new PCV hose. Do not separate these pieces.
13.
Orient the PCV installation jig with the "top" pointed up and place the jig over the PCV elbow. Using a small mallet, gently tap the PCV elbow
into the surge tank until the installation jig is flush with the surge tank.
NOTE:
By orienting the installation jig with the "top" mark up, the finished angle of the PCV elbow will be 100 above horizontal (this is the desired
installation angle).
14.
Wipe off any excess Loctite 603.