Azera V6-3.3L (2007)
Tire Pressure Module: Service and Repair
TPMS RECEIVER
REPLACEMENT
NOTE: When the receiver first arrives for replacement:
a. It will be in Virgin State.
b. It will not be configured for any specific platform.
c. It will not have any sensor ID's memorized.
CAUTION: It is important to make sure that the correct receiver is used to replace the malfunctioning part i.e. Low line: 958003L500, High
Line: 958004D100 in order to have the correct inflation warning thresholds set.
1. Disconnect vehicle battery.
2. Remove malfunctioning part and replace new part.
1. Installation is the reverse of removal.
NOTE: Make sure the connector are plugged in properly.
3. Re-connect battery and turn Ignition on.
4. Check that TPMS lamp flash rate matches Virgin State indication.
5. Connect "TPMS exciter" to the diagnostic connector.
